Why Is My Toilet Running All The Time In San Diego?
Nothing is more irritating than watching someone flush the toilet and realizing minutes later that the annoying running sound isn’t going to end. It becomes a constant source of annoyance since the sound is difficult to ignore. That means somebody would have to get up and “jiggle the handle” for the running to come to a halt.
The toilet has an internal water leak, which causes this common nuisance. Even though it appears to be not harmful, it is potentially wasting hundreds of gallons of water, as shown by your water bill.
So, why does your toilet keep running, and what would you do about it?
Step 1: Check The “Toilet Flapper”
A common cause of running toilets is the toilet flapper. These flaps act as a seal for the water tank in your bathroom. They will deteriorate and crack as they get older. When this happens, the toilet flapper has difficulty lifting the lift arm in the tank by pulling on a chain attached to the toilet flapper, allowing water to fill the toilet bowl. The problem arises, however, when the flapper fails to drop back.
Step 2: Check The Chain
Because of the cracks or injury, water continues to leak into the toilet bowl, resulting in the sound of running water. If the toilet flapper seems to be worn out, you should try fixing it yourself. They can be found at your neighborhood hardware store. Turn off the water supply at the valves under the toilet, flush, and then empty the bowl of any remaining water. If you miss the target, the seal won’t fit if the chain is too short. You’ll have to do a test flush to make sure you have it in the right place.
Step 3: Check The Toilet Tank Float Ball And Arm
Because of their names, these components are self-evident. The plastic ball is the first thing you’ll notice when you take the lid off the toilet tank. It’s attached to an arm, and they rise and fall together as the tank fills and empties. They aim to assist in monitoring water levels, and when the ball reaches a certain level, the water is turned off. To see if it’s working correctly, raise the float arm to see if the water stops flowing.
Since the arm is off-kilter, the ball can hit the tank if it isn’t high enough to stop the running water. You should try bending it away from the tank wall to see if it makes a difference. If the ball and arm tend to be in alignment, the ball may be cracked, causing it to fill with water and fall to the bottom of the tank.
Find Long-Term Solutions
This is where we enter the image. We will quickly eliminate the irritating running water sound and save you money on water waste as your San Diego leak detection plumber. Give us a call right now at 1st Response Leak Detection!
