How To Detect A Silent Toilet Leak In San Diego
Make an attempt to identify your toilet model, either by searching it on the internet or by calling a local plumbing company. It will make the process easier and more accurate if you know what type of valve and gasket you need.
Leaking valves can be identified by looking underneath for signs of water dripping from the base of the tank into the bowl’s overflow tube. The overflow tube is located inside the tank, just below where it sits atop its base. The water around this area may indicate a leak even if it isn’t visible in the toilet bowl itself. If not torn, worn gaskets can be replaced easily at home with replacement parts found at most hardware stores. If simply unplugging and re-plugging your flapper doesn’t fix the problem, however, you may need to replace it.
Flushing mechanisms are different between tank-type toilets and older pressure-assisted models. In older pressure-assisted tanks, water drains from the open bottom of the tank once all flushing action ceases. It is not uncommon to find mineral deposits built up around these drain holes that can clog them over time. Mineral deposits built up on modern float valves should be scraped away with a thin tool before they can cause problems.
Float valves in newer pressure-assisted tanks are known for being fragile if mishandled while cleaning or repairing them. If your toilet malfunctions after you’ve made no changes to your toilet’s plumbing whatsoever, it might be time to get a new one.
Recalibrating the float on a new pressure-assisted tank can ensure an appropriate amount of water in the tank at all times. Sometimes they stick in the “up” position and allow too much or too little water in, which prevents it from flushing correctly and can cause mineral deposits to accumulate faster.
Let the Professionals Do It
If you’re not confident tinkering with it yourself, have a plumber adjust the float for you.
In some older toilets, mineral deposits may be found on the sides of the tank’s interior or along its base. This is a sign that your water has too much iron in it and needs to be filtered before going through your water system again. Iron buildup can cause the dangerous rusting inside of your toilet if left untreated long enough – fortunately, this issue is easy to solve by purchasing a water filter.
Most valves are controlled by levers, which extend down into the valve body when pushed up from underneath. The location of these levers depends on the model, but they are usually located just above where it meets either backstop wall in order to prevent damage.
Let the experts of 1st Response Leak Detection handle your issue. Give us a call at (619) 374-8554 to avail of our services in San Diego, CA.